Arduino Prototyping shield PCB met headers voor UNO

Referentie
TSX00083
Swipen voor 1 additionele foto
€ 13,95 € 11,53
15 in voorraad
Details
Ideaal voor het ontwerpen van je eigen op maat gemaakte Arduino projecten.
  • Vereist een Arduino bord
  • Arduino 1.0 pinout
  • Reset button
  • 14 pin SMD footprint
  • 20 pin through hole footprint
  • SPI header
  • Long and easy-to-solder groun
  • 5V rails
Meer informatie
Meer informatie
Referentie TSX00083
EAN code 02003309506349
Merk ARDUINO
Technische specificaties

SH: Schematics

Arduino Proto Shield is open-source hardware! You can build your own board using the following files:

EAGLE FILES IN .ZIP

SCHEMATICS IN .PDF

Power

The Proto Shield bring the power from the Arduino standard IOREF and GND pins to the two power bus rows placed between the Through Hole prototyping are, which can be used for powering correctly your project independently on the chosen board (3V3 or 5V).

SPI Connection

On the ICSP connector only 5V and GND are wired to the respective pins on the header. MOSI and MISO are present only on the connector and on the near extra pads.

For more information about the SPI communication see the SPI library.

Physical Characteristics

The maximum length and width of the Proto Shield PCB are 2.7 and 2.1 inches respectively. Three screw holes allow the shield to be attached to a surface or case. Note that the distance between digital pins 7 and 8 is 160 mil (0.16"), not an even multiple of the 100 mil spacing of the other pins.

* Ondanks een zeer uitgebreid voorraadsysteem, is het mogelijk dat de voorraadstatus niet overeenstemt met de actuele voorraad. Aarzel niet ons te contacteren, indien u zekerheid wenst over de beschikbaarheid. 

** De weergegeven foto bij de producten kan verschillen van het eigenlijke product.